THERMAL DISCHARGE VALE FOR BOILERS WITHOUT OVERHEATING SEPRENTINE DBV1 97oC, 3/4"M

• In stock · 1–3 bus. days
• Official Gilės Inžinerija supply chain · 24-month warranty & after-sales service
• Full on-site installation & commissioning available (+370 693 97098 · info@gilesinzinerija.lt)

1. 01 · Verify thread & nominal diameter (DN)

   Confirm that THERMAL-DISCHARGE-VALE-FOR-BOILERS-WITHOUT-OVERHEATING-SEPRENTINE-DBV1-97OC connection matches the supply/return pipework and flow direction arrow.

2. 02 · Mount the body onto the isolated branch

   Depressurise the heating circuit, fit the union tailpiece and tighten to factory torque.

3. 03 · Set hydraulic pre-setting / control parameter

   Adjust the flow scale (Kvs / l/h) or controller setting according to room or boiler loop load.

4. 04 · Pressurise, bleed air & verify tightness

   Refill the loop, vent trapped air and verify leak-free operation under operating temperature.

How to avoid the most common installation mistake with THERMAL-DISCHARGE-VALE-FOR-BOILERS-WITHOUT-OVERHEATING-SEPRENTINE-DBV1-97OC?

Always observe the flow-direction arrow on the housing, depressurise the loop before fitting, and never apply hemp or tape onto flat union gaskets or O-ring cones.