ECOMAX 920i main automatization includes: touch screen, control unit, plastic installation box

• In stock · 1–3 bus. days
• Official Gilės Inžinerija supply chain · 24-month warranty & after-sales service
• Full on-site installation & commissioning available (+370 693 97098 · info@gilesinzinerija.lt)

1. 01 · Verify thread & nominal diameter (DN)

   Confirm that ECOMAX-920I-MAIN-AUTOMATIZATION-INCLUDES-TOUCH-SCREEN connection matches the supply/return pipework and flow direction arrow.

2. 02 · Mount the body onto the isolated branch

   Depressurise the heating circuit, fit the union tailpiece and tighten to factory torque.

3. 03 · Set hydraulic pre-setting / control parameter

   Adjust the flow scale (Kvs / l/h) or controller setting according to room or boiler loop load.

4. 04 · Pressurise, bleed air & verify tightness

   Refill the loop, vent trapped air and verify leak-free operation under operating temperature.

How to avoid the most common installation mistake with ECOMAX-920I-MAIN-AUTOMATIZATION-INCLUDES-TOUCH-SCREEN?

Always observe the flow-direction arrow on the housing, depressurise the loop before fitting, and never apply hemp or tape onto flat union gaskets or O-ring cones.

Underfloor heating master controller, 10-zone, supply 230V, supports 12 Danfoss actuators 24V, NC – 088H0017